Husqvarna 45-0352 - Manual (Page 12)

12
FIGURE 28
4. Lubricate the wheel bearings each season. Remove the
hub cap and apply a few drops of light weight oil.
5. Every two years, remove the wheels and clean the gears
found inside the wheel housing. After cleaning, lubricate
the gears with an even coat of light grease. To remove
the wheel, pop off the hub cap and remove the lock nut,
fl at washer and hub cap washer. See fi gure 28.
SCHEDULED MAINTENANCE
1. Clean the sweeper after each use.
2. Inspect for worn or damaged parts, such as brushes
and wheels.
3. Lubricate the brush shaft bearing twice a year with a
few drops of light weight oil. See fi gure 27.
HEIGHT ADJUSTMENT SLOT
HEX BOLT
OIL BEARINGS HERE
FLAT WASHER
FIGURE 27
1. Clean the sweeper and hopper bag thoroughly to help
prevent rust and mildew.
2. To collapse the hopper bag for storage, remove the two
hopper support rods from the rear of the hopper.
3. Store in a dry area.
CAUTION: Before storing the sweeper,
always empty the hopper bag to avoid
spontaneous combustion.
HEX BOLT FLAT WASHER
FLAT WASHER
NYLOCK NUT
HUB CAP SPACER
HUB CAP
WASHER
CLEANING
6. Clean sweeper housing with a soft brush or cloth.
7. Clean debris from hopper bag with a brush or broom.
8. Remove any material which has wrapped around
brushes or ends of brush shaft.
MAINTENANCE
STORAGE