Husqvarna 45-0352 - Manual (Page 6)

6
FIGURE 8
STEP 11 - ASSEMBLE EXTENSION SPRING
18. Assemble a 5/16" x 1" hex bolt and a 5/16" nylock nut
into the top hole in the height adjustment handles. See
fi gure 8.
19. Assemble the extension spring onto the end of the upper
bolt and the middle bolt in the height adjust handles.
Assemble a 5/16" nylock nut onto each bolt so that one
thread of the bolt extends through the nut. See fi gure 8.
FIGURE 9
5/16" NYLOCK NUT
5/16" x 1" HEX BOLT
EXTENSION SPRING
5/16" NYLOCK NUT
STEP 13 - ATTACH HEIGHT ADJUST STRAP
TO ANGLE BRACKET
21. Place the height adjust strap between the angle bracket
and the height adjustment handle. Attach the height adjust
strap to the angle bracket using a 5/16" x 1" hex bolt,
the small spacer, a 5/16" washer and a 5/16" nylock nut.
Tighten. See fi gure 10.
CURVED
HEAD BOLT
HEIGHT
ADJUSTMENT
TUBE
BOWED
WASHER
5/16" LOCK
WASHER
5/16" HEX NUT
5/16" WASHER
5/16" NYLOCK NUT
SPACER (SMALL)
5/16" x 1" HEX BOLT
HEIGHT ADJUST
STRAP
STEP 12 - ATTACH HEIGHT ADJUST HANDLE
20. Assemble the height adjust handles to the height
adjustment tube on the front of the sweeper housing.
Use two curved head bolts, bowed washers, 5/16" lock
washers and 5/16" hex nuts.
Do not tighten yet. See
fi gure 9.
FIGURE 10
5/16" WASHER 5/16" NYLOCK NUT
5/16" x 1"
HEX BOLT
STEP 14 - ATTACH HEIGHT ADJUST STRAP
TO HEIGHT ADJUST HANDLE
22. Attach the height adjust strap to the height adjust handle
using a 5/16" x 1" hex bolt, 5/16" washer and 5/16" nylock
nut. Place the washer against the slot in the height adjust
strap. Tighten the nut and then loosen 1/2 turn so that the
strap can slide freely. See fi gure 11.
23. Slide the height adjust handle so that it aligns with the
height adjust strap and the angle bracket. Tighten the
height adjustment handle in place. See fi gure 11.