Hitachi DZ-GX5020A - Manual (Page 29)

English
29
Turning DVD Video Camera/Recorder On and
Off
While holding down the gray button at the right
of power switch, set the switch according to
each recording function:
Power ON status
During playback, set the power switch to “O”
or “N” when using disc, or set it to “P” when
using card.
Note :
• Once you turn the DVD video camera/recorder on to
let it recognize the disc, you can immediately record
or play back by turning the DVD video camera/
recorder on again. However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder to start
because it must recognize the disc again (see
“Troubleshooting” on page 135).
• It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on.
• When the DVD video camera/recorder is turned on,
the self-diagnosis function will work and a message
may appear. In this case, refer to “Trouble Messages”
on page 129 and take corrective action.
Set to “OFF”:
The DVD video camera/
recorder will turn off
Set to “P”:
To record still on SD
memory card
Set to “O”:
To record movie on DVD-
RAM/DVD-RW/DVD-R/
+RW disc
Set to “N”:
To record still on DVD-
RAM disc
Power switch
Turn the switch while
holding down the gray
button at the right of switch.