Recording using led light (for dz-gx5080a only) – Hitachi DZ-GX5020A User Manual

Page 42

Advertising
background image

English

42

1<>2/3

Recording using LED Light (for DZ-GX5080A only)

You can use the LED light to illuminate a subject to be recorded in a dark place.

1

Press the e button during recording pause or recording.
An icon will appear on the screen, and the LED light will glow.

2

Press the e button again.
The LED light will go out.

Note

:

Pressing e will turn the LED light on and off

alternately.

The LED light will go out if you perform the following:

- Display the Disc Navigation screen
- Start playback
- Switch to demonstration mode

Recording with LED light on will shorten the battery

life more than recording with LED light off.

Do not turn the LED light on with your eyes near it.

Also, be sure not to look directly into the light emitting
portion when the LED light is on: Doing so could
cause visual disorder, such as decreased sight. And
especially: Do not record small children at close-up
distance with the LED light turned on.

Do not use the LED light while pointing at a driver in

vehicle: Doing so could dazzle the driver, causing an
accident.

Do not use the LED light in a place where there is

flammable or explosive gas: Doing so could cause fire
or explosion.

Do not block the light emitting portion when the LED

light is turned on: Doing so could generate heat.

Do not display the LED light beam reflected on a

mirror, etc. on TV screen: Doing so could cause
burning of screen.

Once you press the e button to turn the LED light

on, it will remain on until the e button is pressed
again, which is different from the conventional flash.

When using the LED light for recording, set the

distance to subject at no more than 4.9 feet (1.5 m).

8 : 0 0 A M

2 / 1 0 / 2 0 0 7

3 0 MIN

0 : 0 0 : 0 0

FINE

REM

LED light icon

LED light

Advertising
This manual is related to the following products: