Henny Penny OFG-391 - Manual (Page 14)

Model OFG- 391
Problem Cause Correction
HEATING OF SHORTENING SECTION (Continued)
Heating of • Supply line too small - low • Increase supply line size
shortening too gas volume Refer to Installation
slow Instructions Section of
Operator’s Manual
• Improper ventilation • Refer to Installation
system Instructions Section of
Operator’s Manual
• Observe burners
• Check gas pressure.
• Improper air flow to burners • Check blower for resriction of
airflow
Shortening • Programming wrong • Check temperature setting
overheating in the Program Mode
• Faulty PC board • Remove and replace control
panel
• Faulty temperature probe • Remove and replace
temperature probe
1-8 305