HP B1000 - Manual (Page 118)

118 Chapter 4
Field Replaceable Units
FRU Removal and Replacement
Figure 4-22. Removing the CD Drive Rear Cover
3. Rotate the system unit around until you see the front of the unit as shown in Figure
4-23.
Figure 4-23. Front of System Unit with the Front Panel Removed
4. Remove both CD Drive bracket screws (T-15 Torx screws) and pull the CD Drive bracket
out of the chassis assembly as shown in Figure 4-24. Next remove the four CD Drive
blank screws (T-10 Torx screws) as shown in Figure 4-24. and remove the blank from
the bracket. You are now ready to mount the CD Drive into the CD Drive bracket.
Rear Cover
Handle
T-15 Torx/slotted
Screw
Power Cable
ATAPI Cable
Audio
Cable
Rear
Cover
LCD Display
System Power Switch
CD Drive Blank
Floppy Disk Drive Blank