HP B1000 - Manual (Page 124)

124 Chapter 4
Field Replaceable Units
FRU Removal and Replacement
Figure 4-32. Installing the CD Drive Blank
6. Tighten the two CD Drive bracket screws as shown in Figure 4-33.
Figure 4-33. Tightening the Bracket Screws
7. Place the ATAPI cable and power cables inside the CD Drive chassis, and position the
cables so that they go under the bottom edge of the CD Drive’s rear cover. The rear
Bracket Guide
Blank
Bracket Runner
CD Drive Mounting
Screws
CD Drive Bracket
Bracket Screws
Bracket Screw
Bracket Screw