Husky HD1500 - Manual (Page 18)

18
English
8.0 TROUBLESHOOTING
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Detergent is not dispensing Detergent suction tube has been
disconnected or clogged.
Remove the soap lance assembly from the de-
tergent bottle. Make sure that the clear tube is
properly connected to the soap lance. If it is not
connected then reconnect it.
Detergent to Water ratio Your Powerwasher draws detergent at a 10:1
ratio. Most pressure washer detergents are gene-
rally concentrated within that range so minimal
adjustment is required. If you feel like you are
using more detergent than is required for the ap-
plication you can dilute it with regular tap water.
Detergent - What to use We recommend that you use a cleaner which is
specifically designed for power washers. There
are different kinds available depending on the
application. Check with your local Home Depot
store for the product which is best suited for
your needs.
Never use Bleach, Ammonia or Hot
water in the unit.
Circuit breaker trips or Fuse
blown in Fuse Box Circuit overload Check that the circuit is rated at 15 amps or
greater. Make sure the unit is plugged into a
dedicated circuit.
Extension cord too long or wire
size too small Use proper extension cord as recommended in
owner’s manual.
Nozzle partially blocked Clean Nozzle as instructed in section 6.2.
Excessive pressure Clean Nozzle as instructed in section 6.2
GFCI Plug installation
GFCI Plug malfunction
For GFCI reset procedures see owner’s manual
section 4.3. For instructions regarding the GFCI
Plug installation or malfunction please email us
directly at customerservice@huskypowe
rwasher.com
.
Gun/Hose - Leaking water Gun/Hose will need to be replaced. Replace-
ment parts are not available for the Gun/Hose.
Email us at customerservice@huskypow
erwasher.com
for assistance or order onli-
ne at www.huskypowerwasher.com.
Leaking Oil from Pump A small amount of leakage is
normal If leakage occurs please contact us directly at custo
[email protected].
Leaking water from bottom
of unit Machine Inlet connection is de-
fective Check the Machine Inlet at the back of the unit to
ensure that water is not leaking from it. If the con-
nection is leaking it will have to be replaced.
Contact us at customerservice@huskypow
erwasher.com
or order a replacement directly
online at www.huskypowerwasher.com.