Husky HD1500 - Manual (Page 20)

20
English
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
No water coming out of
Wand Gun/Hose Assembly is defec-
tive Attach the Gun/Hose to the front of the unit with no
wand attached to the Gun. Squeeze the trigger of
the gun to ensure that water comes out of the front
of the Gun at a rate equal to the Garden Hose. If no
water comes out of the Gun, remove the gun and
the hose to ensure that water flows out of the pump.
If it does, the gun will need to be replaced. Contact
us at customerservice@huskypowerwash
er.com
or order a replacement directly online at
www.huskypowerwasher.com .
Trigger will not move Gun Safety Lock in engaged Release Safety Lock as instructed in Manual.
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit is not turned on Press ON/OFF Switch into ON position.
Loose or disconnected Plug Reconnect Plug.
Defective GFCI Plug Perform GFCI reset procedure as instructed in
Section 2.0. If the Plug does not reset it will
need to be replaced. Contact us at custome
[email protected]
or
order a replacement directly online at www.
huskypowerwasher.com
.
Extension Cord length or gauge
incorrect Use proper Extension Cord as instructed in section
2.0.
Gun trigger not operating pro-
perly Contact us at customerservice@huskypow
erwasher.com
or order a replacement directly
online at www.huskypowerwasher.com.
Defective Gun Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced. Contact us at
customerservice@huskypowerwasher.
com
or order a replacement directly online at
www.huskypowerwasher.com .
Tripped Pressure washer Ther-
mal Switch Allow to cool and restart unit.
Defective ON/OFF Switch Contact us at customerservice@huskypow
erwasher.com
or order a replacement directly
online at www.huskypowerwasher.com.
Unit will not stop when trig-
ger is released Screen filter is clogged Clean the Screen filter as instructed in the sec-
tion 6.4.
Garden Hose is kinked or
leaking water Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.
Wand is malfunctioning Test both wands to ensure that one is not mal-
functioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.