Honeywell 51130 Series - Manual (Page 6)

If you store your Honeywell HEPA air cleaner for more than 30 days,
we recommend:
• Remove both the primary HEPAfilter and the activated carbon pre-filter from the unit.
• Discard the pre-filter.
• Wrap the HEPA filter in an air-tight plastic bag or plastic wrap. Be sure that the
filter is totally sealed.
• To restore the air cleaner to service, unwrap the HEPA filter, install a new
activated carbon pre-filter, and replace both filters in the air cleaner.
(See "How to Change the Filters" section for proper installation.)
Storage
• Start on highest speed for a few minutes, then adjust to desired speed.
• Check to make sure that the power cord is correctly connected to the outlet.
• Test that the outlet is functioning properly using another appliance or lamp.
• Check the fuse or circuit breaker. The outlet may be overloaded if other appliances
are also in use. Determine and correct the cause of the overload.
• If none of the above procedures restore operation, return your unit to the store or if the
store's return policy does not allow, return the complete unit per the instructions in the
warranty section of this owner's guide. Do not attempt to repair the unit yourself. Doing
so may cause damage or personal injury and the warranty does not cover damage
resulting from unauthorized attempts to repair or from any use not in accordance with
this manual.
Troubleshooting