Haan Floor Sanitizer SI-35 - Manual (Page 17)

www.haanusa.com 877-HAAN DIRECT / 877-422-6347 pg 15
PROBLEM: Floor Sanitizer leaves water on the floor.
Possible Cause:
1) Ultra-Microfiber cleaning cloth is too wet.
2) Unit is not level on the floor..
Possible Solution:
1) Turn off unit, unplug from power outlet
and change the Ultra-Microfiber pad.
2) Always keep the floor sanitizer level and
parallel to the floor.
PROBLEM: Floor Sanitizer left a white spot on the floor.
Possible Cause:
1) Floor sanitizer left in one spot too long.
2) Floor sanitizer not rested on floor
protector pad.
3) Hard water.
Possible Solution:
1) Always place the floor sanitizer on the floor
protector pad when not in use.
2) Use distilled water.
NOTE: To remove spot, use a damp, dry cloth
with a few drops of white vinegar and rub the
stain to remove spot.
QUEStiOn: Can the HAAn floor sanitizer be used on
laminate flooring?
The HAAN floor sanitizer was designed for use on sensitive
flooring like laminates. We’ve spent years optimizing the
steam emission so that at nearly half the wattage of competitive
products (ours is only 800w versus most that are 1500w),
we still emit steam at 212˚F. This means our finer vapor-like
steam is gentler than those that simply blast 1500w of water
and steam onto your floor. Yet, the HANN is more effective
at penetrating stains and killing harmful germs and bacteria
than competitors. Steam is all we do, and we’ve spent years
perfecting it.
HELPFUL HAAN HINT:
For optimal performance,
the Ultra-Microfiber pad
should be changed after
10 minutes of use.
?