Hearth and Home Technologies Direct Vent Gas Appliance COLBAY-FS-B - Manual (Page 28)

Page 28 10/08 Quadra-Fire • Columbia Bay • 250-5195 Rev. K
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• U s i n g n o n - l i s t e d a c c e s s o r i e s v o i d s
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING
C. Door Crown Installation
IMPORTANT! PREVENT PERMANENT STAINING!
2 Screws
2 Screws
Use a soft cloth and a window cleaning solution to clean
all fingerprint oils from the gold or nickel surface of crown
PRIOR to lighting the appliance.
Figure 8.1 Remove the door from the appliance. Remove
the existing black crown by removing the four screws on the
back side of the face, and pull the crown off the door.
Figure 8.2 Set the replacement gold crown in place, reinsert
screws and tighten.
D. Brick Installation
TOOLS REQUIRED: Phillips head screwdriver.
REMOVAL OF METAL REFRACTORY BRICK
Figure 8.3 To remove existing metal refractory remove the
two screws located on the left and the two on the right sides
behind the side curtains.