Hearth and Home Technologies Direct Vent Gas Appliance COLBAY-FS-B - Manual (Page 30)

Page 30 10/08 Quadra-Fire • Columbia Bay • 250-5195 Rev. K
Figure 8.9 Place right and left front logs on burner in the grooves
provided on the burner surface.
F. Mineral Wool
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Figure 8.10 Place twig over the locator pin on the rear log,
gently laying the log across the two front logs. To complete
your log set application reinstall the front of the unit.
Remove the grille: Slide the grille out of the slots in the exist-
ing door.
Remove the existing door from the appliance.
Remove the crown from the existing door by removing four
screws on the back side of the door assembly. Pull crown
off door face.
Install replacement door with glass onto appliance.
Reinstall the crown.
Reinstall the grille onto the new door assembly.
G. Glass Door Replacement
Handle glass assembly with care.
CAUTION
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.
Figure 8.11 Place individual pieces of embers in front of and
around the gas log where they can be seen. Space them so
that gas can contact them on all sides. Avoid stacking the
embers on top of each other.
NOTE: Do not block gas ports.