Assembly step, Assembly step 2 – Horizon Fitness HORIZON SERIES EX-56 User Manual
Page 5
BEFORE
YOU
BEGIN
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
HORIZON
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
HORIZON WARRANTY
IMPORT
ANT
PRECAUTIONS
A) Open
HARDWARE BAG FOR STEP 2.
B) Carefully pull the
CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C) Attach the
CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
D) Insert the
TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E) Slide
CONSOLE MAST BOOT down to seal the console mast hole.
DO NOT PINCH WIRES!
ASSEMBLY STEP
CONSOLE MAST
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
MAIN FRAME
CONSOLE MAST BOOT
TOP FRONT COVER
TOP BACK COVER
CONSOLE WIRES
#0-5 "
NN
2UZ
413*/(8"4)&3 #
NN
2UZ
'-"58"4)&3 $
NN
2UZ
HARDWARE BAG FOR STEP 2 CONTENTS :
ASSEMBLY STEP 2
CONSOLE MAST
LOWER HANDLEBAR
PRE-ATTACHED
BOLT & WASHER
UPPER HANDLEBAR
PRE-ATTACHED
SET SCREWS
NOTCH
TAB
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove
PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B) Slide
LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
C) Slide
UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are
joined together completely. Secure
UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET
SCREWS.
D) Snap the front and back
HANDLEBAR COVERS together onto the UPPER HANDLE BARS.
Note the position of the snap tabs on the covers before snapping into position.
E) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
FRONT
HANDLEBAR
COVER
BACK
HANDLEBAR
COVER
UPPER
HANDLEBAR
LOWER
HANDLEBAR
EX-56_User_Guide_Rev.1.2.indd 8-9
3/29/07 11:55:37 AM