Horizon Fitness ELITE SERIES 4.3E - Manual (Page 5)

BEFORE
YOU
BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 2
FLAT WASHER (E)
BOLT (F)
FOOT LEVELER
MAIN FRAME
FOOT LEVELER AXLE
A) Open HARDWARE BAG FOR STEP 2.
B) Slide FOOT LEVELER AXLE through MAIN
FRAME TUBE. (The FOOT LEVELER AXLE
is on top of bottom styrofoam, beside
the side shroud).
C) Slide left and right FOOT LEVELERS
onto MAIN FRAME.
D) Attach FOOT LEVELERS using a
WASHER (E) and BOLT (F) on each side
of the MAIN FRAME.
BOLT (F)
20 mm
Qty: 2 FLAT WASHER (E)
16 mm
Qty: 2
HARDWARE BAG FOR STEP 2 CONTENTS :
PEDAL ARM
PIVOT TUBE
FLAT WASHER (H)
WAVY WASHER (I)
FLAT WASHER (J)
BOLT (K)
ASSEMBLY STEP 3
SCREW (G)
12 mm
Qty: 8
A) Open HARDWARE BAG FOR STEP 3.
B) (For Model 4.3E only) Fit RUBBER PAD
into bottom of FOOT PAD with traction
nubs facing up.
C) Attach FOOTPAD to LOWER LINK ARM
PLATE using 4 SCREWS (G).
D) Repeat on other side.
FOOT PAD
LOWER LINK ARM PLATE
SCREW (G)
RUBBER PAD
(4.3E only)
ASSEMBLY STEP 4
HARDWARE BAG FOR STEP 3 CONTENTS :
BOLT (K)
13 mm
Qty: 2
FLAT WASHER (H)
29 mm
Qty: 2
FLAT WASHER (J)
27 mm
Qty: 2
WAVY WASHER (I)
23 mm
Qty: 2
SCREW (L)
15mm
Qty: 2 SCREW (M)
12mm
Qty: 2
HARDWARE BAG FOR STEP 4 CONTENTS :
A) Open HARDWARE BAG FOR STEP 4.
B) Attach PEDAL ARM to PIVOT TUBE using FLAT WASHER (H), WAVY WASHER (I), FLAT WASHER (J), and
BOLT (K).
C) Repeat on other side.
2.3E-4.3E_Rev.1.9.indd 8-9 10/4/06 2:27:25 PM