Horizon Fitness ELITE SERIES 4.3E - Manual (Page 6)

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 
PRE-ATTACHED
BOLT AND WASHER
PRE-ATTACHED
WASHERS CONSOLE MAST
LOWER HANDLEBAR
ASSEMBLY STEP 4 (CONTINUED)
A) HARDWARE BAG FOR STEP 4 (continued).
B) Attach the PEDAL ARM COVER to the right PEDAL ARM using SCREW (L).
C) Repeat on the other side.
D) Attach the ROLLER WHEEL COVER to the right PEDAL ARM using SCREW (M).
E) Repeat on the other side.
F) Insert GUIDE RAIL END CAP into right GUIDE RAIL socket
E) Repeat on the other side.
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
C) Repeat on other side.
D) (For 2.3E only) Attach WATER BOTTLE CAGE using PRE ATTACHED SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support. WARNING
ROLLER WHEEL COVER
PEDAL ARM COVER
PEDAL ARM
SCREW (M)
SCREW (L)
GUIDE RAIL END CAP
PRE ATTACHED SCREWS
WATER BOTTLE CAGE
2.3E-4.3E_Rev.1.9.indd 10-11 10/4/06 2:27:29 PM