HONDA RM752A - Manual (Page 12)

Front Corner Baffle Installation (figure 2)
Attach front corner baffle (5) up under mower frame
as shown and attach with bolts (8) and flange lock-
nuts (9).
Ensure both slde skids, the left side shield and
elther the chute or rlght slde shleid
are installed.
Right Side Shield Baffle Installation
(flgure 2)
FRONT CORNER
INSTALLATION
INSTALLATION
INSTALLATION
1. Mower frame
2. Right side skid
3. Discharge chute
4. Right side shield
5. Front corner baffle
6. Side shield baffle
7. 3/8 x 1" Bolt
8. 3/8 x Carriage
9. Flanged hex locknut
10. Lockwasher
11. Hex nut
Figure 2. Right Skid, Shield & Discharge Chute
When right side shield (4) is installed, you
I
install side shield baffle (6). Attach rear portion of
baffle (6) to mower frame with bolt (8) and flange
locknut (9) as shown. Attach front end of baffle (6)
to side shield (4) with bolt (8) and flange locknut (9)
as shown. Attach side shield (4) to mower frame
with bolts (7) and flange locknuts (9) as shown.
Discharge Chute Installation (figure 2)
The discharge chute (3) may be installed in place of
baffle (6) and side shield (4). Attach discharge chute
(3) to right side of mower with bolts (7) and flange
locknuts (9) as shown.
Right Side Skid Installation (figure 2)
The right skid (2) also serves as a guard. Do not
operate mower unless it is in place and in good
condition.
Attach right side skid (2) to mower frame (1) as
shown with bolts lockwashers (10) and nuts
(11). Do not tighten this hardware as the skid will
require adjustment when cutting height is set.
Caster Arm Installation (figure
1. Mower frame
2. Caster arm
3. Adjustment bracket
A
5. 1/2 x Carriage bolt
6. Flanged hex locknut
4. 1/2 X
Figure 3. Caster Arm Installation
10 F-7756 (1 0-89)