HONDA RM752A User Manual
Page 27
2.
With snap rings removed, support drive in vise,
hold yoke in hand and tap on yoke to drive cup out
of yoke. See figure
20.
Figure 20
3.
Clamp cup in vise as shown in figure
21
and tap
on yoke to completely remove cup from yoke.
Repeat steps
two and three
for
opposite
cup.
Figure
21
4.
Place universal cross in
shown in figure
22
and tap on yoke
to
remove cup. Repeat step
three for final removal. Drive remaining cup out with
drift
and
hammer.
Figure 22
Assembly
1.
Place seals securely on bearing cups. Insert
cup into yoke from outside and press in with hand
pressure as far as possible. Insert journal cross into
bearing cross with grease fitting away from shaft.
Be careful not to disturb needle bearings. Insert
another bearing cup across from first cup and press
in as far as possible with hand pressure.
Trap cups in a vise and apply pressure. Be sure
journal cross is started into bearings and continue
pressure with vise, squeezing in as far as possible.
Tap yoke to aid in process.
2.
Seat cups
by
placing a drift (slightly smaller
than the cup) on cup and rapping with hammer.
(See figure 23.) Install snap ring and repeat on
opposite cup.
F-7756 (1 0-89)
25