Specifications model lp350 – HP Triplex Ceramic Plunger Pump LP400 User Manual

Page 3

Advertising
background image

3

Specifications

Model LP350

Volume ................................................................................................... Up to 22.6 GPM
Discharge Pressure ................................................................................. 2350 PSI
Inlet Pressure .......................................................................................... Up to 90 PSI
Maximum Crankshaft Speed ................................................................... Up to 1000 RPM
Plunger Diameter .................................................................................... 30mm
Stroke ..................................................................................................... 42mm
Crankcase Oil Capacity .......................................................................... 100 fl.oz.
Temperature of Pumped Fluids ............................................................... 140

o

F @1000 RPM

............................................................................................................... 160

o

F Up to 500 RPM

Inlet Port ................................................................................................ 1-1/4" BSP+
Discharge Port ........................................................................................ 1" BSP++
Shaft Mounting ...................................................................................... Either side
Shaft Rotation ............................................................................ Top of pulley towards manifold
Weight .................................................................................................... 105 lbs.
Crankshaft Diameter ............................................................................... 35mm

+
++

PULLEY INFORMATION

Pulley selection and pump speed are based on a 1725
RPM motor and "B" section belts. When selecting
desired GPM, allow for a ±5% tolerance on pumps
output due to variations in pulleys, belts and motors
among manufacturers.
1.

Select GPM required, then select appropriate

motor and pump pulley from the same line.
2.

The desired pressure is achieved by selecting the

correct nozzle size that corresponds with the pump
GPM.

HORSEPOWER INFORMATION
Horsepower ratings shown are the power require-
ments for the pump. Gas engine power outputs
must be approximately twice the pump power
requirements shown above.
We recommend that a 1.1 service factor be specified
when selecting an electric motor as the power source.
To compute specific pump horsepower requirements,
use the following formula:

HP = (GPM x PSI) / 1440

LP350 PULLEY SELECTION AND HORSEPOWER

REQUIREMENTS

PUMP

PULLEY

MOTOR

PULLEY

RPM GPM 500 PSI 1000 PSI 2000 PSI 2300 PSI

12.75"

3.95"

500 11.3

3.9

7.8

15.7

18.0

12.75"

4.95"

640 14.5

5.0

10.0

20.1

23.1

12.75"

5.75"

750 16.9

5.9

11.8

23.5

27.1

12.75"

6.15"

805 18.2

6.3

12.6

25.3

29.0

12.75"

6.55"

865 19.5

6.8

13.6

27.1

31.2

12.75"

6.95"

940 21.2

7.4

14.7

29.5

33.9

12.75"

7.50"

1000 22.6

7.8

15.7

31.4

36.1

Advertising
This manual is related to the following products: