Hobart Welding Products 150 - Manual (Page 27)

OM-210 088 Page 23
5-5. Cleaning Or Replacing Piecemaker 14-A Gun Liner
Ref. ST-801 995
1/16 in
To Reassemble Gun:
Insert new liner.
Push liner against quick-connect
plug, and tighten set screw.
Cut liner off so that 3/4 in (19.05
mm) sticks out of head tube.
Install adapter, contact tip, and
nozzle.
Lay gun cable out straight
before installing new liner.
Head Tube
1/2 in
Remove liner.
Remove nozzle, contact tip,
adapter, and wire outlet guide.
Blow out gun casing.
Y Disconnect gun from unit.
Tools Needed:
1/16 in
Loosen liner set screw.
Quick-Connect Plug
NOTE: Burrs or bent wire from spring
may make it difficult to feed wire
through the liner. Remove burrs