Connecting external video sources, Input mode selection order, Input – Hitachi 55DMX01WD User Manual

Page 18: Video:1 12, Video:2, Video:3, Ant a 32 ant b

Advertising
background image

18

CONNECTING EXTERNAL VIDEO SOURCES

The exact arrangement you use to connect the VCR, camcorder, laserdisc player, and DVD player to your TV set is dependent on the
model and features of each component. Check the owner’s manual of each component for the location of video and audio inputs and
outputs.

The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your particular
assortment of components and features. For best performance, video and audio cables should be made from coaxial shielded wire.

Before Operating External Video Source
The input mode is changed every time the INPUT button on the Front Panel is pressed as shown below. The VID1~VID3 buttons on
the remote control will select each video source each time they are pressed. The ANT button on the remote control will select between
ANT A and ANT B. Connect an external source to the INPUT terminals, then press the INPUT button as necessary to view the input
source. (See page 26)

NOTE:

When the Rear Projection TV is set to VIDEO and a video signal is not received from the VIDEO INPUT jack on the back
panel of the Rear Projection TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the TV set
will appear to be OFF.

CONNECTING A MONAURAL AUDIO VCR OR LASERDISC PLAYER

1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack on the TV set below.

2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.

3. Press the VID1~VID3 button on the Remote Control to view the program from the VCR or the laserdisc player. The VIDEO icon

disappears automatically after approximately eight seconds.

4. Press the ANT button to return to the previous channel.

INPUT

VIDEO:1

12

INPUT MODE SELECTION ORDER

(INPUT)

(INPUT)

(INPUT)

VIDEO:2

INPUT

INPUT

VIDEO:3

INPUT

INPUT

ANT A

32

ANT B

(VID1)

(VID2)

(VID3)

(ANT)

(ANT)

ANT A

TO
CONVERTER

ANT B

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

AUDIO

L

R

(MONO)

VIDEO

VIDEO

AUDIO

(MONO)

L

R

AUDIO

(MONO)

L

R

VIDEO

S-VIDEO

Y

S-VIDEO

Y

B

R

P

P

B

R

P

P

S-VIDEO

L

R

L

R

SUB
WOOFER

STOP

CONNECT ONLY 8 OHM SPEAKERS
DO NOT SHORT CIRCUIT
THESE TERMINALS
(Such damage is NOT COVERED
by your television warranty)

REAR SPEAKER

8

Ω ONLY

-

L

+

-

+

R

OPTICAL

INPUT

COAXIAL

INPUT

PC RGB INPUT 1

PC AUDIO

INPUT 1

MONITOR

OUT

INPUT 2

INPUT 1

AUDIO

TO HI-FI

Rear Panel of Television

Hitachi Model or

Similar Model

VCR

VIDEO OUT

AUDIO OUT

Advertising