Hitachi 55DMX01WD - Manual (Page 9)

9
FRONT PANEL JACKS AND CONNECTIONS
NOTE: Optional adapter for *Apple® Macintosh® computers. If the optional AESP model G301/U Macintosh to VGA® adapter
connector is configured and connected between Macintosh video out and the Rear Projection Television video in, the
Macintosh is “forced” to boot in 640 x 480/60 Hz or 800 x 600/60 Hz mode (set mode) because the operational adapter
correctly manipulates the Macintosh sense pins.
For the optional adapter to work, it’s DIP switch settings should be # 2, 3, 6, 7 = ON and # 1, 4, 5, 8, 9, 10 = OFF.
See below: Example - See Switch Instructions for details.
Mode 5 = 2367 (SVGA 800 x 600/60 Hz configuration)
(VGA 640 x480/60 Hz configuration)
Composite Separate Sync
ON DIP
1 2 3 4 5 6 7 8 9 10
ON
1 4 5 8 910
2 3 67
OFF
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 SW9 SW10
ON ON ON ON
OFF OFF OFF OFF OFF OFF
A/V Cable and
S-INPUT Cable
(Optional)
Back of VCR
D-SUB 15 Pin
RGB Cable
(Optional)
PC
AUDIO OUT
Back of PC
Audio Cable
(Optional)
S-VHS Video Camera Output
̇
VIDEO 3
VOL-
̇
̇
AUDIO IN
VIDEO 3/PC2
L/(MONO) R VIDEO S-VIDEO
PC2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
INPUT VOL+ CH- CH+
TV/PC EXIT
MENU
̈ SELECT ̇
VIDEO 3
VOL-
̇
̇
AUDIO IN
VIDEO 3/PC2
L/(MONO) R VIDEO S-VIDEO
PC2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
INPUT VOL+ CH- CH+
TV/PC EXIT
MENU
̈ SELECT ̇
VIDEO 3
VOL-
̇
̇
AUDIO IN
VIDEO 3/PC2
L/(MONO) R VIDEO S-VIDEO
PC2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
INPUT VOL+ CH- CH+
TV/PC EXIT
MENU
̈ SELECT
V L R S-VIDEO
OUTPUT
NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may
be abnormal. If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable. If you have a
mono VCR, insert the audio cable into the left audio jack of your TV. INPUT 3 audio can be used for PC INPUT 2 audio
when a PC INPUT 2 is connected.
The front panel jacks are provided as a convenience to allow you to easily connect a VCR, PC or camcorder as shown in the
following examples: