HP ProLiant DL385 - Manual (Page 97)

Server cabling 97
5. Install the SCSI terminator board.
Removing the SCSI terminator board
1. Power down the server ("Powering down the server" on page 35 ).
2. Extend or remove the server from the rack ("Extending the server from the
rack" on page 37 ).
3. Remove the access panel.
4. Remove the front fan bracket ("Front fan bracket" on page 43 ).
IMPORTANT: For this procedure, you do not need to remove the hot-
plug fans from the front fan bracket. When reinstalling the front fan
bracket, press the top of each fan to be sure it seats securely.
NOTE: For more information on preparing the server for installation or
removal procedures, refer to the Documentation CD.