Horizon Fitness HORIZON TREADMILL GS1050T - Manual (Page 10)

10
ASSEMBLY STEP 5
BOLT (G)
15 mm
Qty: 2 FLAT WASHER (J)
15 mm
Qty: 2 BOLT (K)
12 mm
Qty: 2
HArDWArE bAG 5 CONTENTS :
CONSOLE
CONSOLE MAST
BOLTS (G)
FLAT WASHERS (J)
BOLTS (K)
HANDLEBAR
HANDLERBAR BOOT
A Open HArDWArE bAG 5.
B Slide left HAnDLEbAr to ConSoLE and
attach using 1 boLT (K).
C Slide HAnDLEbAr booT UP over bottom of
HAnDLEbAr.
D Attach left HAnDLEbAr to ConSoLE MAST
using 1 boLT (G) and 1 fLAT WASHEr j).
E Slide HAnDLEbAr booT down to cover
HAnDLEbAr-MAST conection.
F Repeat on other side.
G Connect power plug to the treadmill and
connect the cord to a power outlet. The on/
off switch is located next to the power cord.
Flip this switch to the ‘ON’ position, so that
the switch is lit. You will hear a beep and the
console will turn on.
H Before the first use, lubricate the treadmill deck by
following the instructions in the MAINTENANCE
section in the TREADMILL GUIDE.
ASSEMBLY COMPLETE!