Horizon Fitness HORIZON TREADMILL GS1050T - Manual (Page 7)

7
ASSEMBLY STEP 2
A Pull LEAD WirE through riGHT ConSoLE MAST.
After pulling the lead wire through the mast, the top of the
ConSoLE CAbLES should be located at the top of the
mast. Detach and discard LEAD WirE.
B Open HArDWArE bAG 2.
C Move riGHT LinKAGE ArM into position and attach to
ELEvATion frAME. While holding riGHT ConSoLE
MAST in the upright position, tighten PrE-ATTACHED
boLT using flat wrench to attach riGHT LinKAGE ArM.
D Attach riGHT ConSoLE MAST to MAin frAME
using 1 boLT (D), 1 fLAT WASHEr (E) and 1 WAvy
WASHEr (f).
E Lift the rUnninG DECK until fooT LoCK LATCH on
side of treadmill is fully engaged.
F Remove ConSoLE from box and place out of the way.
G Lower the treadmill rUnninG DECK from the folded position
by stepping on fooT LoCK LATCH on lower right side.
WAVY WASHER (F)
29 mm
Qty: 1
BOLT (D)
Qty: 1
FLAT WASHER (E)
27 mm
Qty: 1
HArDWArE bAG 2 CONTENTS :
BOLT (D)
FLAT WASHER (E)
WAVY WASHER (F)
CONSOLE CABLE
RIGHT CONSOLE MAST
LEAD WIRE
MAIN FRAME
RIGHT LINKAGE ARM
ELEVATION FRAME
PRE-ATTACHED BOLT FOOT LOCK LATCH
If you have attempted to move the treadmill from the box and
the machine has sprung open and cannot be assembled, refer
to the troubleshooting section in the TREADMILL GUIDE in
order to restore the treadmill to its proper position.
ATTEnTion
NOTE: Be
careful not to
pinch any wires
while assembling
the right console
mast.