Heat & Glo Fireplace PIER-TVFL st-42tvfl - Manual (Page 15)

21
The diagram below shows how to properly position,
level, and secure the fireplace.
1. Place the fireplace
into position.
2. Level the fireplace
from side to side and
from front to back.
3. Shim the fireplace
with non-combustible
material, such as
sheet metal, as
necessary.
4. Secure the fireplace to
the framing by nailing
or screwing.
Figure 8. Proper Positioning, Leveling, and
Securing of a Fireplace
Step 6
The Gas Control
Systems
WARNING: THIS UNIT IS NOT FOR USE
WITH SOLID FUEL.
Direct Spark Ignition (DSI) or Standing Pilot (Millivolt)
gas control systems are used in these models.
Standing Pilot Ignition System
This system includes millivolt control valve, standing
pilot, thermopile/thermocouple flame sensor, and
piezo ignitor.
WARNING
110-120 VAC MUST NEVER BE
CONNECTED TO A CONTROL VALVE IN
A MILLIVOLT SYSTEM.
Direct Spark Ignition (DSI) System
This system includes a 110V control valve, electronic
module (with internal transformer) and spark ignitor/
flame sensor.
WARNING: CONTINUOUS 110 -120 VAC
SERVICE MUST BE DIRECTLY WIRED
TO THE FIREPLACE JUNCTION BOX IN
A DSI SYSTEM.
Step 5
Positioning,
Leveling, and
Securing the
Fireplace
NAILING TABS
AT BASE OF
FIREPLACE.
!
!
!