Hitachi C47-WD8000 - Manual (Page 20)

20
ON-SCREEN DISPLAY MENUǏFUNCTION MENUǐ
Function Menu
Function menu allows you to select scan mode, decorative light on the front panel and multi picture mode, etc.
Please follow the steps below.
1
Press the MENU button to display the menu.
Press the Ÿ ź cursor buttons to select the Function
option as shown on the right.
2
Press the ENTER button to enter the Function menu.
Press the Ÿ ź cursor buttons to select the Scan Mode option
as shown on the right.
3
Press the ENTER button to enter the Scan Mode menu
as shown on the right.
You can press the Ż Ź cursor buttons to select different
scan modes to improve picture effect.
˄1˅For PAL or SECAM systemˈyou can select scan mode
from 100Hz,Virtual HD or Progressive.
˄2˅For NTSC system, you can select scan mode from
Virtual HD or Progressive.
˄3˅When the input signal format is 480p signal, the scan
mode setting will be fixed at Progressive.
˄4˅When the input signal format is 576p signal, you can
select scan mode from 100Hz or Progressive. The 100Hz
mode can eliminate flicker.
˄5˅When the input signal format is 1080i/60 or 720p/60 HD signal, the scan mode setting will be fixed at HD.
˄6˅When the input signal format is 1080i/50 HD signal, you can select scan mode between 100Hz or HD. The
100Hz mode can eliminate flicker.
4
If the Decorative Light option on the Function menu is selected, you can turn the blue lighting on the control
panel On or Off. When the TV is in standby or the power is off, the lighting on the front panel will be off.
Scan Mode 3URJUHVVLYH
6HW 5HWXUQ
Ź
3LFWXUH  
$XGLR
7LPHU
)XQFWLRQ
6HWXS
6HOHFW6HW
Ź
䗝乍 Ϟϔ义 䆒ᅮ
)XQFWLRQ     
6FDQ0RGH    

 3URJUHVVLYH
'HFRUDWLYH/LJKW 2II
7936L]H ([SDQGHG
$XWR36L]H 2Q
0XOWL3LFWXUH 
3KRWR 
5HVHW 
  6HOHFW 6HW 5HWXUQ
Ź
ź