Hitachi C47-WD8000 - Manual (Page 33)

33
MULTI PICTURE
The Multi Picture function of this projection TV provides two modes, Split and P in P. To use the Multi Picture
function allows you to enjoy the programs easily and comfortably.
In normal picture mode, press the MULTI PIC. button to enter the Split or P in P mode.
ǏSplitǐ
Follow the steps on page 20 to enter the Function menu and
select the Multi Picture option, then enter the Multi Picture
menu and select the Multi Picture option as shown on the
right.
Press the Ż Ź cursor buttons to set Multi Picture option to
Split mode, then exit from the menu.
ƽIn normal picture mode, press the MULTI PIC. button to
enter the Split mode as shown below. Picture A and B will
show the programs of two channels respectively.
ƽOnce you have entered the Split mode, press the A/B button
to select any one of the two pictures. A red symbol
will appear on top of the selected picture, indicating:
˄1˅The TV speakers will output the sound from the selected
picture.
˄2˅The monitor out terminals will output audio and video
signals from the selected picture.
˄3˅The operations such as program selection, etc. are valid
for the selected picture. However, the program No.
selected in one picture cannot be the same as that in the
other one. Otherwise, the characters !Not Available will
appear.
Notes˖
˄1˅When the RECALL button is pressed, the picture A and B will display their respective program No.
instantly, and the red symbol will appear on the top of the selected picture momentarily.
˄2˅If the HP Select option in the Multi Picture menu is set to B, the headphone terminal of the side panel will
always output the sound from picture B. If the HP Select option in the Multi Picture menu is set to A/B,
the headphone terminal of the side panel will output the sound from the selected picture.
ƽIn the Split mode, you can press the SWAP button to switch between the two pictures, ie, to exchange the
program sources of picture A and B.
ƽIf the Freeze option in the Multi Picture menu is set to Still, while in the normal TV mode, pressing the
FREEZE button will enter the Split mode automatically. Picture A will display the current active program
and picture B will display a freeze frame of the TV program captured at the moment you press the FREEZE
button. MONITOR OUT terminals will output audio and video signals from picture A. Please refer to page 37
for information if the Freeze option in the Multi Picture menu is set to Strobe.
ƽIn the Split mode, the POSITION button does not work.
ƽIn the Split mode, press the MULTI PIC. or the RETURN button to exit.
ƽIn the Split mode, you may enter the Audio menu to make adjustment by pressing the MENU button. However,
if you enter other menus such as Picture, it will exit from the Split mode.
A B
 

䗝乍 Ϟϔ义 䆒ᅮ
0XOWL3LFWXUH 
0XOWL3LFWXUH 6SOLW
&+6XUI 
)UHH]H 6WLOO
+36HOHFW $%
5HVHW
 
 
 
6HOHFW 6HW 5HWXUQ
ź
Ź