Hitachi HUS103036FL3800 - Manual (Page 20)

Drawing No. Sheet No. Revision
K6610091 20/43 2005/2/23
6 SCSI Interface
6.1 Summary of SCSI Controller
The Ultrastar 10K300 SCSI controller interfaces between the drive and the host
computer with the Small Computer System Interface (SCSI).
(1) ANSI standard
The controller supports the SCSI interface that conforms to the ANSI specifications
shown in section 2.
(2) Compact design
The controller is embedded within the disk drive.
(3) Fast data transfer rate
The controller can transfer data via asynchronous mode, Fast-5 synchronous mode,
Fast-10 synchronous mode and Ultra (Fast-20) synchronous mode.
The controller can transfer data via Ultra2 (Fast-40) synchronous mode and Ultra160
(Fast-80) synchronous mode and Ultra320 (Fast-160) synchronous mode, as well as
above-mentioned transfer mode.
(4) FIFO buffer
The Ultrastar 10K300 SCSI controller has 8M bytes of FIFO buffer. This data
buffering feature prevents the SCSI controller from delay during the reconnect
process and reduces the latency time that is generated by the difference of the data
transfer rate between media and host.
(5) Automatic error retry
The controller automatically retries whenever the disk drive encounters errors.
(6) Automatic error corrections
The controller uses On-The-Fly ECC to automatically correct read
errors, without latent rotational time.
(7) Parameter save feature
The controller saves the controller/device parameters (MODE SELECT parameters)
specified by the host onto the disk drive. The parameters are automatically restored
at power-on time.