Hitachi HUS103036FL3800 - Manual (Page 28)

Drawing No. Sheet No. Revision
K6610091 28/43 2005/2/23
8.4 Other Precautions
8.4.1 Do not loosen the screws or disassemble the drive.
8.4.2 Do not remove the PCB from the drive or swap the PCB with other drives.
8.4.3 Do not solder the wire or other parts on the PCB, or reconstruct the PCB.
8.4.4 Do not remove the sealing tape or label on the HDA.
8.4.5 Turn off the power before removing or installing the DC power cable and
SCSI interface cable. Turn off the power before removing or installing the
jumper.
8.4.6 Remove the DC power and SCSI interface connectors carefully in order
not to damage the contact pins and the connector housing.
8.4.7 Do not move the drive when the disks are rotating or while the power is
on or for 20 seconds after the power has been turned off.
9 Maintenance
9.1 The HDD itself is maintenance free and there are no individual parts that require
maintenance. If maintenance for the HDD is required, the entire product will need
to be serviced, since it can not be divided into parts. System maintenance should
be executed by the host system.
9.2 The supplier will repair or exchange the product due to malfunction covered
under the warranty. The warranty and service will be agreed upon between the
customer and the supplier. The supplier is neither liable or obligated to service
any product due to carelessness or mishandling of product.
9.3 Even if the drive fault occurs during the In-warranty period, the supplier will repair
or replace the drive but will not be liable for any expenses of disk drive
installation or detachment to or from system. (This includes data back up, data
copy, etc.)