Hitachi 65F710A - Manual (Page 59)

59
65” Disassembly/Assembly Instructions
Useful Information
IMPORTANT POINTS:
(a) Do not attempt to perform this work by yourself.
(b) Request an installation specialist to install this unit.
(c) HITACHI assumes no responsibility or liability for injury/damage as a result of consumer installation and
handling. Be advised that improper consumer installation/handling is not covered by manufacturer’s warranty.
(d) This Projection Television weighs 309 pounds and has many sensitive components.
CAUTION: DISCONNECT UNIT FROM POWER SOURCE BEFORE DISASSEMBLY/ASSEMBLY
DISASSEMBLY PROCEDURE
NOTE: Read all instructions and understand how to properly and safely disassemble and assemble unit
STEP 1
Before disassembling this projection TV set, you
must first remove the speaker grille by grabbing
the sides and pulling left and right side see (a)(b).
Remove the front decoration panels by unscrewing
the 2 screws from each panel, see (c), then
remove from the original position, see (d)(e).
STEP 2
Remove the 8
screws that hold
the screen frame to
the cabinet on the
front side. DO NOT
remove the right and
left edge screen
frame screws (c).
STEP 3
Remove the sensor box by unscrewing the 2
screws located on both sides of the sensor box,
see (a). Rotate the sensor box and there are 4 low
voltage connectors located on the sensor board,
see (b). Disconnect wires (PDSE), see (c) and (d).
(Make sure to push the center lock on the
connector at the unplug time.)
(a) (b)
(c) (d) (e)
(a) (b) (c)
(a) (b)
(c) (d)