Holder C 9.92 H - Manual (Page 86)

C 9.92 Operating Instructions
84 153 146
Operating the attachments
Adjusting the catch hooks
The catch hooks can be adjusted laterally and in length.
-
Measure the distance between the pins on your
attachment.
- Release the clamping screws (8) on both sides.
- Slide the catch hook (7) laterally until the required
distance is reached.
- Retighten the clamping screws.
- Attachments of Category II can be picked up directly
with the catch hooks (7).
- For attachments of Category I install the reducer
sleeves (6) on the left and right hook.
Adjusting the hitch insert length
- Loosen the lock nuts and clamping screws (1) at the
lower link (2).
- Loosen the screw at the pin (3) and pull the pin out.
- You can adjust the hitch inserts (4) to one of 3 positions.
- Insert the pin (3) into the hole and secure with the
screw.
- Retighten the locknut and clamping screws (1).
DANGER
Never let anyone stand between the tractor
and an attachment or implement.
1 2 3 4 5
6
7 8
Bild_S 990_018
- Drive the tractor to the attachment to be picked up.
- Steer the catch hooks (7) below the pick-up pins of the
attachment.
- Raise the front lift, until the quick detach coupling (5)
closes and engages.
Hole Position Used for
1st hole Front Category I and II
2nd hole Centre Category I
3rd hole Rear Special attachments