Husqvarna crt51 - Manual (Page 52)

52
5. Repair and adjustment 5. Reparatur und Einstellung
5. Réparations et réglages 5. Herstellen en afstellen
5. Riparazioni e messa a punto 5. Reparación y ajuste
1. Handle (low position)
2. Handle (high position)
3. Handle lock lever
4. Belt guide
5. Engine pulley
6. Idler pulley
7. Extention spring
8. Transmission pulley
9. Drive control cable
10. Cable clip screw
Position handle
Loosen handle lock lever (fig. 16). Handle can be positioned
at different settings between "high" and "low" positions (fig.
16). Retighten handle lock lever.
NOTE!
Select handle height suitable for you and your tilling condi-
tions. Handle height will change when tiller digs into the soil.
WARNING!
Stop the engine and remove the spark plug wire and cover
from the spark plug (fig. 7) before cleaning out the tines by
hand. Use caution - tines are sharp.
CAUTION!
Place blocks under transmission to keep tiller from tipping.
Ground drive belt adjustment
For proper belt tension, the extension spring (fig. 17) should
have about 5/8 inch stretch with drive control bar in engaged
position (fig. 9). This tension can be obtained as follows.
a. Loosen cable clip screw securing the drive control cable
(fig. 17).
b. Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained.
c. Tighten cable clip screw securely.
Figure 16
Figure 17
1
2
3
Eng
4
9
10
8
7
6
5