Husqvarna 210 C - Manual (Page 17)

18 - English
3. INSTALLATION
Tip! If, for reasons of space or for some other reason,
it is not suitable to charge the mower where the loop
generator/charger is positioned, a freestanding
charger can also be used. A charger can be
purchased as an accessory. Contact your dealer for
further information.
Installation and connecting the loop
generator/charger
1. Position the loop generator/charger in a suitable spot.
2. Connect the loop generator/charger's power cord
to a 230 V wall socket. It is preferable to use an
earth-fault breaker as recommended.
3.3 Charging the battery
Automower is supplied with an uncharged battery. As
soon as the loop generator/charger is connected, it is
possible to charge the mower.
1. Set the main switch to the ON position.
2. Connect the charger cable from the loop
generator/charger to the charger contact on the
mower. The green indicator lamp Battery should
now be lit with a steady light. The indicator lamp
goes out when the mower is fully charged.
3. From an uncharged state the battery takes about
12 - 15 hours until it is fully charged.
Tip! Leave the mower connected to the charger
cable when not in use. As long as the mower is
connected it will be maintenance charged, which
means the battery will be fully charged when the
mower is used.
IMPORTANT INFORMATION
Automower cannot be used before the
installation is complete.
3012-784
3012-758