Husqvarna 210 C - Manual (Page 40)

English - 41
8. TROUBLE SHOOTING
8. Trouble shooting
8.1 Fault messages
A number of fault messages that can be shown by the red Fault indicator lamp on Husqvarna
Automower™ are shown below. The fault message is interpreted by reading how the lamp flashes. The
lamp flashes one to five times in quick succession and then goes out for 2 seconds. This sequence is
repeated until the Cancel button is pressed. For example, three flashes in the table below corresponds to
the lamp flashing three times in quick succession, and then going out.
Always try to restart the mower if the Fault indicator lamp is lit or flashes. Restart the mower by pressing
the Cancel button, enter your PIN code and close the cover
If the same fault occurs frequently, or if the Fault indicator lamp is lit with a steady light: contact your
dealer.
Flashes Fault message Cause Action
1 Wrong PIN code Wrong PIN code has been
entered. Three attempts are
permitted, the keypad is then
blocked for five minutes. Enter the correct PIN code.
1 Charger cable not
connected The charger cable is not
connected when changing the
PIN code, or when connecting
the mower to the loop
generator/charger. Connect the charger cable
2 No loop signal The loop generator/charger is
not connected to the mains
supply or its miniature
circuit-breaker has tripped. Check the wall socket connection and
whether the miniature circuit-breaker has
tripped.
Reset the miniature circuit-breaker by
removing the loop generator/charger's power
cord from the wall socket, wait 10 seconds
and then reconnect the power cord in the
wall socket again.
Boundary wire broken. Check the signal given by the LED on the
loop generator/charger. If it flashes the loop
is damaged. Repair the broken cable using
an original waterproof coupler.
The connection between
Automower and the charging
station has been lost. Link the mower to the loop
generator/charger by changing the PIN
code, see page 30. You can use the same
PIN code as earlier. You can use the same
PIN code as earlier.
This may be due to the
boundary wire being routed in
the wrong direction around an
”island”, which blanks out the
signal. Check that the boundary wire has been
routed correctly.
If this occurs in isolated areas
it may be due to interference
from metallic objects
(perimeter fence,
reinforcement bar) or buried
cables in the vicinity. Try moving the boundary wire.
3 No drive Automower has got caught in
something. Free the mower and rectify the reason for
the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the
mower.