Husqvarna 210 C - Manual (Page 25)

26 - English
3. INSTALLATION
3.5 Connecting the boundary wire
Connect the boundary wire to the loop
generator/charger:
1. Place the cable ends in the connector:
• Open the connector.
• Place the wire in the connector grip.
2. Press the connector together using a pair of
pliers. Press until you hear a click.
3. Cut off any surplus boundary wire. Cut 1 - 2 cm
above respective connectors.
4. Attach the connector to the contact pin on the
loop generator/charger.
3012-284
3012-264
3012-265
3012-771