Huffy SKM 3072-U - Manual (Page 5)

IMPORTANT!
Bounce middle pole section onto
top pole section until they no longer
move toward tape reference mark.
Upright assembly.
HOLES IN TOP AND BOTTOM
POLE SECTIONS MUST
ALIGN TO CORRECTLY POSITION
ELEVATOR SYSTEM.
While checking alignment, add
bottom pole section and bounce
sections together as tight as possible.
Bounce sections together
as tight as possible.
NOTE:
POLE SECTIONS MUST OVERLAP
8.9 CM (3-1/2”) MINIMUM.
P/N 205343A 7/97 5
15
Spread collar (12) open and slide top of pole
through to 86 cm (34”) mark on bottom pole
section (13). Install rod (15) thru holes in bottom pole section (13)
and eyebolt (16).
NOTE: Two people recommended for this step.
Secure pole bottom (13) to base using nut (7) and
disk (18), a deep socket is recommended. Install bolt (18), washer (10) and nut (11) in pole
collar (12) at tape mark on bottom pole and tighten.
Mark poles with tape as shown.
TOP
MIDDLE
BOTTOM
7
18
Wood Scrap
8.
10. 11.
12. 13.
10
11
17
13
14
13 cm (5”)
86 cm (34”)
16
IMPORTANT!
DO NOT
OVER TIGHTEN
STEP 12 OR 13,
MAY CRACK BASE.
9.
12
13
13
12
16
13
12
1