Huffy SKM 3072-U - Manual (Page 6)

P/N 205343A 7/97 6
30
19
22
27
20
21
25
24
32
29
29
33
30
31
21
IMPORTANT! Test fit bolts into
holes of brackets (19) and carefully
rock them in a circular motion to ream
out paint from holes if necessary.
IMPORTANT! Finger tighten nuts
and bolts until instructed to fully tighten
later.
Fit spacer (22) into pawl (23) and fit
pin of pawl through end hole of release
lever (24).
IMPORTANT! Bolt (28) must be inserted through tube (29), spacer (30), support bracket (21), board bracket (19),
release lever (24), wave washer (31), and then ratchet (32). Fully tighten all nuts and bolts after assembly.
Use pliers to stretch spring (34) into position.
24
19
21
26
28
34
18.
23
14.
15.
16.
17.
18.