Husqvarna 965881201 - Manual (Page 38)

MAINTENANCE
38 -Husqvarna
Engine Cooling Air Intake
Check that the engine’s cooling air intake is free from
leaves, grass, and dirt.
If the cooling air intake is clogged, engine cooling
deteriorates, which can lead to engine damage.
The cooling air intakes rotates when the engine is
running. Keep fingers away.
8061-014
Check and clean the cooling air intake
Throttle Cable
Check that the engine responds to throttle increases
and that a good engine speed is attained at full
throttle.
If doubts arise, contact the service workshop.
If adjustments are necessary, they can be made as
follows for the lower cable:
loosen the clamping screw for the cable’s outer 1.
casing and move the throttle to the full throttle
position.
Check that the throttle cable is mounted in the
2.
correct hole in the lower lever, see illustration.
Push the throttle cable’s outer casting as far to the
3.
right as possible and tighten the clamping screw.
8011-605
Adjusting the throttle cable
8011-605
Adjusting the choke cable
Choke Cable
If the engine produces black smoke or is difficult
to start, this can be because the choke cable is
incorrectly adjusted (upper cable).
If doubts arise, contact the service workshop.
If adjustments are necessary, they can be made as
follows:
loosen the clamping screw for the cable’s outer 1.
casing and push the choke control fully in.
Check that the choke cable is mounted in the
2.
upper lever, see illustration. Push the choke
cable’s outer casing as far to the left as possible
and tighten the clamping screw.