Husqvarna 965881201 - Manual (Page 53)

lUBRICATION
Husqvarna- 53
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in nature;
it should always be disposed of at a workshop
or appropriate disposal location.
Avoid skin contact; wash with soap and water
in case of spills.
Engine Oil
Engine Oil Filter
Drain the engine oil in accordance with the work •
description under the heading Engine Oil/Change
Engine Oil.
Remove the oil filter. If necessary, use a filter
•
remover.
Wipe new, clean engine oil onto the seal for the
•
new filter.
Mount the filter by hand with +¾ turn.
•
Run the engine warm, then check that there are •
no leaks around the oil filter seal.
Check the oil level in the engine, fill if necessary.
•
The oil filter holds 0.1 qt (0.1 liters) of oil.
8011-734
Changing the oil filter
Deck Outer Spindle
lubricate using a grease gun, one zerk, each side 2-3
strokes. Use only good quality bearing grease.
8061-025
Deck outer spindle (with belt shield removed)
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
engine. Allow the engine to cool to a
safe temperature before draining.