Husqvarna 965881201 - Manual (Page 50)

MAINTENANCE
50 -Husqvarna
Cleaning
Regular cleaning and washing, especially under the
mower deck, will increase the machine’s life-span.
Make it a habit to clean the machine directly after use
(after it is cooled), before the dirt sticks.
Do not spray water on the top of the mower deck. Use
compressed air to clean the top side of mower deck.
Regularly clean deck and underside of the deck with
normal water pressure. Do not use a high pressure
washer or steam cleaner. Avoid spraying engine and
electrical components with water
Do not rinse hot surfaces with cold water. let unit cool
before washing.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill
material to the tires. Excessive loads created
by foam filled tires will cause premature
failures.
Only use O.E.M. specified tires.
8050-831
Clean regularly
IMPORTANT INFORMATION
Use protective glasses when
cleaning and washing.
8011-619-4
1. Caster yoke
2. Caster bolt
3. Caster long spacer
4. Caster small spacers
Caster wheels
2
1
3
Caster Wheels
Check every 200 hours. Check that wheels rotates
freely. If wheels do not rotate freely take the unit to
your dealer for service.
Foam filled tires or solid tires will void the warranty.
Removal and installation of caster wheel
Remove nut and caster bolt.
Pull the wheel out of the yoke and take care of the
spacers.
Install in reverse order. Tighten caster bolt.
Hardware
Check daily. Inspect the entire machine for loose or
missing hardware.
4