Heatiator Heatilator BCDV36 - Manual (Page 3)

01-03 3 33606 Rev D
BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS
A. APPLIANCE SPECIFICATIONS
1. U.S. AND CANADA CERTIFICATION
The Builder's Choice Series Gas Appliance has been tested in accordance with the ANSI standard Z21.50b-1998 and
U.L. 307B in the United States; in Canada, the current CAN/CGA-M2.22-M98, and has been LISTED by Underwriters
Laboratories Inc. for installation and operation as described in this manual. All components are UL, AGA, CGA or CSA
safety certified.
2. LOCAL CODES
This installation must conform with local codes. In the absence of local codes, with the National Fuel Gas Code, ANSI
Z223.1-latest edition in the U.S.A., and the CAN/CGA B149 Installation Codes in Canada.
The Builder's Choice Series gas appliance has been tested and listed for use in manufactured housing (mobile
homes). These installation instructions conform with the Home Construction and Safety Standard, Title 24 CFR,
Part 3280, or when such a standard is not applicable, the standard for Manufactured Home Installations, ANSI
A225.1.
If any assistance is required during installation, please contact your local dealer or contact Heatilator Technical
Services Department, 1915 W. Saunders Street, Mt. Pleasant, Iowa 52641, 1-800-843-2848.
HEATILATOR® is a registered trademark of Heatilator Inc., a Division of Hearth & Home Technologies
3. GLASS CERTIFICATIONS/SPECIFICATIONS
Hearth & Home Technologies gas appliances manufactured with tempered glass may be installed in hazardous
locations such as bathtub enclosures as defined by the CPSC. The tempered glass has been tested and certified to
the requirements of ANSI Z97.1-1984 and CPSC 16 CFR 1202. (Safety Glazing Certification Council SGCC# 1595 and
1597. Architectural Testing, Inc. Reports 02-31919.01 and 02-31917.01).
This statement is in compliance with SPCS 16 CFR Section 1201.5 “Certification and labeling requirements” which
refers to 15 USC 2063 stating “ Such certificate shall accompany the product or shall otherwise be furnished to any
distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory. Please contact your dealer or distributor to order.
Note: Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions reflect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
Tools and building supplies normally required for
installation:
Saw
Wall-finishing materials
Pliers Framing material
Hammer Appliance surround
Phillips screwdriver Caulking material
Tape measure Safety gloves
Plumb line Framing square
Level Electric drill and bits
Safety glasses
WARNING!
DO NOT use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
CAUTION:
Do not expose the appliance to the elements (such as rain, etc.).