Wall or under-table mounting, Wall or under-table mounting -13 – HP 2520G-POE User Manual
Page 33
2-13
Installing the Switch
Installation Procedures
Wall or Under-Table Mounting
You can mount the switch on a wall with either the front or rear panel facing
up.
W A R N I N G
For safe operation, do not install the switch with side ventilation or
fan ducts facing up or down.
For the Switch 2520G-8-PoE, the network ports must be facing up. Do
not mount the switch with ports facing down.
C a u t i o n
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch (12.7 mm) plywood or its equivalent.
1.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
2.
Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Figure 2-7. Wall Mounting the Switch 2520G-24-PoE
Wall
5/8-inch
wood screws
RJ-45 Ports