Operation – HONDA Outdoor Motor BF50A User Manual
Page 55
53
OPERATION
ENGINE COVER GRIP
TILT LEVER
R
R
U
U
N
N
(
(
L
L
O
O
C
C
K
K
)
)
T
T
I
I
L
L
T
T
Do not use the tiller handle as a
lever to raise the outboard motor.
Applying excessive f orce to the tiller
handle can damage it.
An excessive tilt angle during
operation can cause propeller
ventilation, overheating, and water
pump damage. This type of damage
is not covered by the
(p.
).
106
Monitor water flow from the cooling
system indicator (p.
) to be sure
the outboard motor is not tilted so
high the water intake is out of the
water.
While the outboard motor is tilted,
proceed at a low speed, and do not
operate the outboard motor in reverse.
The outboard motor will rise
suddenly if operated in reverse.
To tilt the outboard motor, move the
tilt lever to the TILT position, then
raise the outboard motor to the
desired position by pulling on the
engine cover grip.
Distributor’s
Limited Warranty
To return the outboard motor to the
normal operating position, move the
tilt lever to the RUN (LOCK)
position, you may need to raise the
outboard motor slightly to disengage
the tilt mechanism, then slowly lower
the outboard motor.
29
05/02/22 10:53:11 31ZW3600_054