HONDA Outdoor Motor BF50A - Manual (Page 80)

78
STORAGE
If the fresh water supply is
insufficient it may be necessary
to temporarily cover the three
water intakes with duct tape as
shown on the following page.
COOLING SYSTEM INDICATOR WATER INTAKES
WATER INTAKES
Running the engine without good
water circulation can cause
overheating and water pump damage.
Distributor’s Limited Warranty
Move the gearshift lever or control
lever to the N (neutral) position.
Flush the outboard motor in the
neutral position only.
Turn on the fresh water supply to
the flush kit coupler.
Damage caused by running the
outboard motor without sufficient
cooling water is not covered by the
(p. ).
Start the engine. Monitor the
cooling system indicator. Stop the
engine if water does not come out
of the cooling system indicator and
check the fresh water supply.
4.
5.
6.
106
05/02/22 10:56:45 31ZW3600_079