Hobart Welding Products BETA-MIG 1800 - Manual (Page 19)

OM-929 Page 15
2-11. Threading Welding Wire
Ref. 802 472 / 802 480
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Outlet Wire Guide
7 Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
6 in
(150 mm)
Pull and hold wire; cut off end.
4 in
(102 mm)
Tighten
Remove gun nozzle and contact tip. Turn On.
WOOD
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Cut off wire.
Close door.
Open pressure assembly. Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure
assembly, and let go of wire.
7
6 1 2 3
4
5
.
Hold wire tightly to keep it
from unraveling.