English – Hitachi 24PD User Manual
Page 8
7
English
PRECAUTIONS ON USING HAMMER DRILL
1.
Wear earplugs to protect your ears during
operation.
2.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
3.
Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
4.
Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
SPECIFICATIONS
Voltage (by areas)*
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
Power Input
620W*
No-load speed
0 – 1050/min.
Full-load impact rate
4400/min.
Capacity: concrete
3.4 – 24 mm
steel
13 mm
wood
32 mm
Weight (without cord and side handle)
2.6 kg
Dust collecting adapter
Max. hole-drilling depth:
100 mm (adjustment possible between 0 and 100 mm)
Diameter of drill:
3.4 – 24 mm
Max. length of drill (overall length):
270 mmm
Dustbag capacity:
0.4 liters
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case (Molded plastic) ................................................. 1
(2) Side handle ................................................................. 1
(3) Dust collecting adapter .............................................. 1
(4) Dust bag ...................................................................... 1
[Numbers (3) and (4) refer to use on concrete]
(5) Cap .............................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Drilling anchor holes (rotation + striking)
⅜ Drill bit (Slender shaft)
⅜ Drill bit (Taper shank) and taper shank adapter
Adapter for slender shaft
(SDS-plus shank)
Drill bit (Slender shaft)
Drill bit (Taper shank)
Taper shank adapter
(SDS-plus shank)
Cotter
Drill bit (slender shaft)
Outer diameter
Effective length
Overall length
3.4 mm
45 mm
90 mm
3.5 mm