Hitachi 24PD - Manual (Page 9)

8
English
( )
⅜ 13 mm Hammer drill chuck
For drilling operations when using a straight shank bit for impact drilling with a hammer drill.
Straight shank bit
for impact drill 13 mm Hammer drill chuck
(SDS-plus shank)
Chuck wrench
2. Anchor setting
⅜ Anchor setting adapter (for electric hammer drill)
Anchor setting adapter (SDS-plus shank)
(for electric hammer drill)
Overall length: 160, 260 mm
⅜ Anchor setting adapter (for manual hammer)
Anchor setting adapter
(for manual Hammer)
3. Crushing operation (rotation + striking)
Bull point (Round type only)
(SDS-plus shank)
Taper mode Applicable drill bit
Morse taper (No.1) Drill bit (taper shank) 11.0 ~ 17.5 mm
Morse taper (No.2) Drill bit (taper shank) 21.5 mm
A-taper Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
B-taper
drill bit for it is not provided.
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
Anchor size
W1/4”
W5/16”
W3/8”
W1/2”
W5/8”
Anchor size
W1/4”
W5/16”
W3/8”