Homelink universal transceiver – HONDA 2009 Pilot User Manual
Page 361
CONTINUED
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 4.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitter may stop
transmitting after a short time.
Go to step 3.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 4.
If the red indicator in HomeLink
continues to flash slowly (does
not begin to flash rapidly),
repeat steps 1 thru 3.
Test the HomeLink button by
pushing it for about 1 second.
If the button works,
programming is complete.
If the button does not work go
to step 5.
Push and hold the HomeLink
button and watch the red indicator
on HomeLink.
If the indicator stays on, press
the HomeLink button again; the
remotely controlled device
should operate.
If the indicator flashes rapidly
for 2 seconds then stays on, you
have a rolling code transmitter:
go to ‘‘Training with a Rolling
Code System’’ (see page
).
2.
3.
4.
5.
HomeLink Universal Transceiver
Fe
a
tu
re
s
357
2009 Pilot