Document Outline

• Table of Contents
• About This Document
  • INTENDED AUDIENCE
  • PREREQUISITE SKILLS OR KNOWLEDGE
  • HOW THIS DOCUMENT IS ORGANIZED
  • CHANGES FROM THE PREVIOUS ISSUE
  • CONVENTIONS USED IN THIS DOCUMENT
  • TRADEMARKS AND SERVICE MARKS
  • RELATED RESOURCES
  • HOW TO MAKE COMMENTS ABOUT THIS DOCUMENT
• 1. Introduction
  • THE NETWORK INTERFACE
  • LOCAL NETWORKING
  • REMOTE NETWORKING
  • NETWORK PLANNING
  • AUDIX NETWORK IMPLEMENTATION
    • AUDIX Software
    • ACC/ACCE
      • TN366 ACC
      • TN366B ACC
      • TN539 ACCE
      • TN539B ACCE
    • Other AUDIX Circuit Pack Requirements
      • One-Cabinet and Two-Cabinet AUDIX System
      • AUDIX Large System
    • Rear Connector Panel and Backplane
      • One-Cabinet and Two-Cabinet AUDIX System
      • Rear Connector Panel and Backplane (Large)
    • Network Cabling Common to Most Configurations
      • H600-330, Group 1 Cable
      • H600-331, Group 2 Cable
      • H600-331, Group 1 Cable
    • AUDIX System Administration
  • NETWORKING ENHANCEMENTS
    • R1V5 Release
    • R1V6 Release
    • R1V7 Release
• 2. Dedicated EIA RS-232 Networks
  • CONSIDERATIONS
  • GENERAL INFORMATION
  • AUDIX REQUIREMENTS FOR DEDICATED RS-232
  • SWITCH (OR CUSTOMER) REQUIREMENTS FOR DEDICATED RS-232
  • DATA RATES FOR DEDICATED RS-232
• 3. Switched EIA RS-232 Networks
  • CONSIDERATIONS
  • SWITCHED RS-232 USING MODEMS
    • AUDIX System Requirements For Switched RS-232 Using Modems
    • Switch (or Customer) Requirements For Switched RS-232 Using Modems
    • Data Rates for Switched RS-232 Using Modems
  • SWITCHED RS-232 USING DATA MODULES FOR DCP
    • AUDIX System Requirements for Switched RS-232 Using Data Modules For DCP
    • Switch (or Customer) Requirements for Switched RS-232 Using Data Modules for DCP
    • Data Rates for Switched RS-232 Using Data Modules For DCP
• 4. DCP Mode 1 Networks (em 56 Kbps
  • CONSIDERATIONS
  • GENERAL INFORMATION
    • Static Access
    • Dynamic Access
  • AUDIX SYSTEM REQUIREMENTS FOR DCP MODE 1
  • SWITCH (OR CUSTOMER) REQUIREMENTS FOR DCP MODE 1
    • Static Access Switch Requirements
    • Dynamic Access Switch Requirements
  • DATA RATES FOR DCP MODE 1
• 5. DCP Mode 2 Networks (em Modem Pooling
  • CONSIDERATIONS
  • GENERAL INFORMATION
  • AUDIX SYSTEM REQUIREMENTS FOR DCP MODE 2
  • SWITCH (OR CUSTOMER) REQUIREMENTS FOR DCP MODE 2
    • Basic Switch Needs
    • DCP Interface for the AUDIX Network Channels
    • DCP Interface for the Digital Side of the Modem Pool
    • Analog (Tip and Ring) Interface to the Interlocation Facilities
    • Analog Interface for the Analog Side of the Modem Pool
    • Modems and Data Modules
    • Rack-Mount Equipment
    • Cabling
  • DATA RATES FOR DCP MODE 2
  • DCP MODE 2 FOR A 5ESS SWITCH
• 6. DCP Mode 3 Networks (em 64 Kbps
  • CONSIDERATIONS
  • GENERAL INFORMATION
  • AUDIX SYSTEM REQUIREMENTS FOR DCP MODE 3
  • SWITCH (OR CUSTOMER) REQUIREMENTS FOR DCP MODE 3
    • Colocated Requirements
    • Interlocation Requirements
  • DATA RATES FOR DCP MODE 3
  • DCP MODE 3 FOR A 5ESS SWITCH
• 7. Mixtures of RS-232 and DCP Networks
  • CONSIDERATIONS
  • RS-232 AND DCP AT THE SAME AUDIX SYSTEM
  • RS-232 AND DCP AT SEPARATE LOCATIONS
• 8. EIA RS-232 Cabling
  • DEDICATED RS-232 CABLING
  • SWITCHED RS-232 CABLING
    • DIP Switch Settings
    • Mixing Modem Types and Modes
    • RS-232 to DCP Conversion
  • SWITCH ADMINISTRATION
• 9. DCP Cabling and Administration
  • ACC(E) WIRING TO THE SWITCH
    • System 75, System 85, and DEFINITY Communications Systems
    • Non-DCP Switch Applications
  • SWITCH ADMINISTRATION
    • System 75, Generic 1, and Generic 3 Administration
    • System 85 Administration
    • Generic 2 Administration
      • Manager III and Manager IV Administration
      • Manager II Administration
• 10. DCP Mode 1 Installation and Administration
  • SWITCH COMPONENT INSTALLATION
  • SWITCH ADMINISTRATION
    • 4ESS Administration
    • System 75, Generic 1, and Generic 3 Administration
    • System 85 Administration
    • Generic 2 Administration
  • LOOPBACK TESTING
    • Loopback Testing for R1V7
    • Loopback Testing for R1V5 and R1V6
      • Setting Up the MPDM/M1*
      • Performing Loopback Test
• 11. DCP Mode 2 Installation and Administration
  • INSTALLING A 2296A AND MTDM IN A MODEM POOL
    • Install the Modem Pool Cabinet
    • Install the Multiple Mountings
    • Install the Modems and Data Sets
    • Install the Multi-Mount Cables
    • Install the MTDM and 2296A Cables
    • 2296A Options Settings (D-Lead Modem Pool)
  • INSTALLING A 7400A IN A MODEM POOL
  • INSTALLING STAND-ALONE MODEM POOLS
    • System 75/85, System 75 XE, Generic 1, Generic 2, and Generic 3
  • ADMINISTERING THE SWITCH FOR MODEM POOLING
    • System 75, Generic 1, and Generic 3 Administration
    • System 85 Administration
    • Modem Pooing Testing
    • Generic 2 Administration
• 12. DCP Mode 3 Instllation and Administration
  • SWITCH COMPONENT INSTALLATION
  • SWITCH ADMINISTRATION
    • System 75, Generic 1, and Generic 3 Administration
    • System 85 Administration
    • Generic 2 Administration
  • LOOPBACK TESTING FOR INTERLOCATED SYSTEMS
• 13. AUDIX System Administration
  • REMOTE UPDATES
    • Partial Updates
    • Complete Updates
    • Network Turnaround
  • SYSTEM PROFILES
  • SETTING UP THE LOCAL AUDIX SYSTEM PROFILE
    • Form Fields
    • Saving Local System Data
  • SETTING UP A REMOTE AUDIX SYSTEM PROFILE
    • Form Fields
    • Saving Remote System Data
  • RECORDING AUDIX MACHINE NAMES
  • ADMINISTERING PORTS
    • Form Fields
    • Saving Data
  • ADMINISTERING SYSTEM LIMITS
    • Form Fields
    • Calculating Filesystem Sizes
    • Comparing the Recommended File Sizes to Actual Sizes
    • Increasing the Size of a Filesystem
  • MOVING A SUBSCRIBER BETWEEN AUDIX SYSTEMS IN A NETWORK
  • ADMINISTRATOR'S WORKSHEET
• 14. AUDIX Network Testing
  • TESTING THE NETWORK CONNECTIONS
    • Step 1: Performing Remote Connection Tests
    • Step 2: Performing Loop-Around Tests
    • Step 3: Performing Channel or Modem Loop-Around Tests
    • Step 3A: Channel Internal Loop-Around Test
    • Step 3B: Modem Loop-Around Test
  • SETTING UP REMOTE UPDATES
    • Step 1: Activitating the Remote Updates Feature
    • Step 2: Testing the Remote Updates Feature
    • Step 3: Performing Voice Mail Test
    • Step 4: Activitating Remote Updates for Additional AUDIX Systems
  • CHECKING ADMINISTRATION LOG ENTRIES
  • TROUBLESHOOTING THE NETWORK
• A. Network Considerations
  • BCSDC CONSIDERATIONS
  • AUDIX NETWORK PLANNING WORKSHEET
• B. Sales Enginerring Notes
  • BASIC AUDIX AND MISCELLANEOUS AUDIX FEATURES
  • DCS NETWORKS AND AUDIX
  • ENGINEERING WORKSHEETS
  • QUALITY PROTECTION PLAN CHANGE NOTICE (QPPCN)
  • UPGRADES, SOFTWARE, AND VINTAGES
• C. AMIS Analog Networking
• Abbreviations
• Glossary
• Index